Welcome to EB-WebHelp
About Using WebHelp
Using Branch Solutions
    About Using Branch Solutions
    EB Cable Automotive
       English
          Manual EBCable Logic & Harness Design
          Getting Results
             1 Installation
             2 My First Project
                2.1 Opening and Closing the Program
                2.2 The Engineering Base Window
                2.3 Creating "My first Project"
                2.4 The Structure within the Project
                2.5 Open a sheet in Visio
                2.6 Create a Usage-Location
                2.7 Extend an Usage Location
                2.8 Placing a Usage Location into the diagram
                2.9 Drawing Connections
                2.10 Create a Potential
                2.11 Create a Harness
                2.12 Create the first Sheet
                2.13 Associate a KAB-Diagram with a Harness
                2.14 Transfer Usage Locations to a Harness
                2.15 Adapt Connections
                2.16 Create a Cut-off-point
                2.17 Associate Cut-off-points to a harness
                2.18 Placing a Cut-off-point into the Diagram
                2.19 Dual connection at a cavity
                2.20 Generate Splices
                2.21 Allocation of Connectors
                2.22 Create Wires
                2.23 Define module view
                2.24 Creation of Connector terminals and (Blind-) Seals
                2.25 Create a connection list
                2.26 Creation of a 2D-Topology-Diagram
                2.27 Create a Harness-Topology
                2.28 Switching between Diagram and Navigation
                2.29 Enter Segment Length and Visualize
                2.30 Routing Wires in Segments
             3 Worksheets and Reports
             4 Next Steps
       German
    EB Cable System Engineering
    Electrical Pro
    Instrumentation
    Minerals Processing
    Power PTD
Using EB
Best Practices
Engineering Base Developer Network
References