1.1           General Information

By means of the Execution Management assistant, objects (equipment, functions, locations, drawings, sheets etc) may be marked for an execution outside of the source project. These objects are allocated to an execution task and may be exported into a new project or a transport container.

After editing, these execution tasks can be transferred back into the source project and merged with the existing data. During this process, information on which objects were deleted in the execution project (deletion list) will also be taken over into the source project, and the respective deletions will also be done there.

In the project properties, you can define the settings for the management of execution tasks.

Prerequisite

Using the assistant requires one of the following licenses:

·            Execution Management (1157)

·            EB Process Engineering(1104)

·            EB Detail Engineering (1105)

·            EB Plant Engineering (1106)

·            EB Plant Engineering (Campus) (1107)

·            EB Plant Operation (1108).

The Execution Management assistant consists of four modules

·            Assign to Execution Task

·            Manage Execution Tasks

·            Export/Transfer of Execution Tasks

·            Delete Execution Task.

Moreover, the assistant Execution Management Merge is available to transfer execution tasks that have been carried out externally back into the source project (As-built project).

Using the Execution Management Compare assistant, you can compare object data in an As-built project and an execution project. The comparison of sheet contents can be started from a sheet.

The worksheet Execution Tasks can be started on the Tasks folder or any of its subfolders to obtain an overview on the defined execution tasks and their status information.