8.27.8                Finishing the connector terminal selection

Once you have selected all connector terminals, seal and blind seals, you can terminate the connector terminal selection with <Finish>.

Thereupon the connector terminal selection creates all objects under the cavities and sets the corresponding attributes at the connector cavities; these attributes represent the status of the terminal calculation for the respective cavity.

Once the assignments to a cavity have been made, the following attributes are set at the affected cavity:

·            Terminal calculation unsuccessful / invalid

·            Seal created

·            Blind seal created

·            Connector terminal created

These attributes are used for controlling the symbol graphic of a connector cavity as well as for another contact calculation. For controlling the symbol graphic, depending on these attributes the symbols are shown as follows:

With <Cancel> you can leave the connector terminal selection without the selection being accepted.