8.14.2                Assigning cable circuit diagrams to wire harnesses

In order for a cable circuit diagram to be recognized as such by EB, it must be assigned to a wire harness.

For this purpose you can create a new sheet e.g. under Document -> 20_KAB, or you can continue with the logically interconnected circuit diagram (SYS plan).

The 2-D cable circuit diagrams must also be assigned to a wire harness because here too the wizards require such an assignment.

A sheet can belong to only precisely one wire harness, but one wire harness can also be assigned to several sheets. However, it is not possible to assign several wire harnesses to one sheet.

Nonetheless you can use drawn frames linked to a wire harness to represent several wire harnesses on a sheet.