If during a deletion process a wire assigned to a wire harness is to be deleted, then the inline connection point or terminal block cannot be deleted.
4.4.5 Removing Inline Connection Points and Terminal Blocks from Wire/Cable Chains
In the Target View, you can mark and then delete wires, inline connection points, their connectors and terminal blocks or terminals by clicking on Remove. The associated wiring is completely updated in this case.
|
|
If during a deletion process a wire assigned to a wire harness is to be deleted, then the inline connection point or terminal block cannot be deleted. |
In principle, terminals, inline connection points and wires are deleted only if all associated wires can be deleted. In particular, the following procedure is kept:
· The explicitly selected single wires are deleted. The wires connected to the other side of the terminal or inline connection point are connected to the corresponding targets of the deleted wires.
· As soon as all single wires of the cable have been taken into account by selecting the objects to be edited, the cable is completely deleted. Should a core of cable remain connected, then the cable in its entirety is not deleted, and a corresponding program message is displayed.
· If an inline connection point is to be deleted, then all pins of the inline connection point must be marked for deletion.
· If a terminal block is to be deleted, then all pins of the terminal block must be marked for deletion.